Single Cylinder Cast Camshaft: Stock Altered Grinds - 6,500 + Range
Single Cylinder Stock Altered Camshaft Grinds
These grinds are rated for open RPM.
All durations are measured @ .050 tappet lift. Select your duration.
Most of these profiles will work well with stock lifters.
A heavier spring than the Kohler spring should be used with these profiles. Suggest using our aftermarket heavier single spring assembly (The factory retainer will not work with our single spring.)
We will build up the lobes with a hard face overlay and regrind your cam core.
Please verify the quality of the ignition points lobe before sending in your core. Excessive wear will result in an insuffecient ignition signal. Inspect the gear teeth for damage. Look for cracks near the base of the gear before sending the core.
Please DO NOT remove the compression release.
You will receive the cam you sent in. Turn around time may be up to 3 weeks. We will return ship the camshaft when full payment has been made.
When mailing in your core, please include all of your contact information and instructions. Use our Packing List form below:
|Engine Make & Model||Kohler K341|