Single Cylinder Cast Camshaft (Open RPM) - V432-6

This profile can be put on a cast camshaft when you are allowed open lift . Example: It is a good grind for a 10 H.P. Open Class.

This camshaft can rev to 7500 and produces a lot of torque.
It has 0.432" lift and a duration rated at 261 degrees at 0.050" tappet lift. It is ground on 106 degrees of lobe center separation.

This profile must have larger lifters such as the 1.280" or 1.400".
This cam requires an aftermarket heavier single spring assembly. Our single spring and retainer assembly works well with this cam.

We will build up the lobes with a hard face overlay and regrind your cam core.

Please verify the quality of the ignition points lobe before sending in your core. Excessive wear will result in an insuffecient ignition signal. Inspect the gear teeth for damage. Look for cracks near the base of the gear before sending the core.
Please DO NOT remove the compression release.

You will receive the cam you sent in. We will return ship the camshaft when full payment has been made.

Due to demand, grind services currently have a turn around time of 4 weeks or less. Thank you for your understanding.

When mailing in your core, please include all of your contact information and instructions. Use our Packing List form below:

Packing List